Same— my understanding is that there’s now no option to play without making one, which for some countries and territories is not even an option, making the game unplayable for them.
Gonna give this a try! I’ve been jumping between clients on my Hyprland desktop… rn I can’t do global PTT on any third-party apps, despite Hyprland passing the input through to the app exclusively. I haven’t even looked at Vesktop, though!
The 45 degree one was really poor quality on the bottom… and the back part snapped when I was trying to remove supports. It likely would’ve been a bit stronger printing with taller layers, but the bottom edge seems tricky to support regardless.
The horizontal one turned out well. The bottom side has a rough finish from where the supports connected, but I think being more picky about painting on supports and giving that side a quick shave after printing would fix. The tip is still pretty smooth, to my surprise! Also, this printed twice as quick as the vertical one, since I didn’t have to slow any movements. I can’t break this one even if I try— it’s super strong, the bridge included. Just bends. That said, the nub on this one is more of a nub than a bump, a bit sharper. Between that and the surface on the bottom, it doesn’t fit in my 3ds without doing any shaving or sanding. However, the “tail” part, which shows in the 3ds, is smoothest off-the-bed in this orientation.
Lastly, I printed another vertical one because I wanted to figure out why the bridge at the bottom wasn’t complete in the sliced model:
My solution was reducing the “minimum perimeter width” for the Arachne generator down to 50% (of the nozzle diameter) from 85%. Anyways, this print has a smoother, shinier finish along the shaft and tip. On this print, the nub near the bottom is more of a gradual bump compared to the horizontal one. With this print, though, as the height increases, you can see a bit of wobble and there is a Z-seam running up the shaft. Also, I don’t trust bending this stylus very much, especially the bridge part, since that’s what broke first last time. Seems sturdier this time with the perimeter change, but only a bit. And finally, the “tail” is the roughest here, since it’s the part that was connected to the raft. It’s probably worth sanding it down to get a good finish there.
I should’ve been a bit more careful with where I put support material— one side of the bridge part is a bit bumpy. But it still works, so I can’t complain too much. Also, the bottom part where it connected to the raft is a bit rough. Might be worth lightly sanding it down so it’s a nicer finish when stashed.
Mobile games company Voodoo acquires BeReal ( techcrunch.com )
Flash Rule ( lemmy.ohaa.xyz )
Helldivers 2 Players Express Frustration On Steam As It Will Soon Require A PSN Account ( www.gameinformer.com )
cross-posted from: https://lemmy.zip/post/14764738...
Vesktop 1.5.2 greatly improves screensharing on Linux ( github.com )
Vesktop is a custom Discord App with an aim to give better performance and support on Linux....
Dr.Eggrule's Dic ( lemmy.world )
You told me Rule ( lemmy.ca )
My stylus broke. Here’s my “you told me so” to @aBundleOfFerrets, @huginn, @optissima, and the creator themself, @the16bitgamer....
Nether Rule ( lemmy.ca )
Lost my 3DS Stylus Rule ( lemmy.ca )
Also I made a new acc so I can use Voyager! Previously used @SmoochyPit....