Need some advice on scanning

I’m having a bit of a hard time with this, but I also acknowledge this is still relatively niche still.

I’d like to make printed recreations of some parts that I currently have. They’re unfortunately a bit complex to quickly recreate manually in a sculpting software. I do have an iPad PRo and a budget for any additional hardware to help. I was hoping I could find a carousel I could connect to the iPad Pro and use and app to control the carousel and scan the parts. I’m not finding anything.

Can anyone recommend a good setup to make 3D scans of these small parts, or an app/hardware combo that could help me accomplish this?

EmilieEvans ,

Regardless of the scanner use matting spray. Either a commercial that evaporates or baby powder + IPA or baking powder.

OpenScan was already meantioned by somebody else.

The CR scan otter won't work for small parts and the CR-scan software isn't great for example there isn't an undo button to remove the last x seconds of bad scan data.

  • All
  • Subscribed
  • Moderated
  • Favorites
  • •
  • [email protected]
  • kbinchat
  • All magazines
    •